Raider RDP-AG63 User Manual page 20

www.raider.bg
20
Fixing grinding disc
Pull out the power plug.
Depress and hold down the spindle lock to tighten the spindle. Turn the shaft until it was locked. Remove the
outer flange and tighten the flange using the special wrench provided.
Fit the desired disc on the inner flange and replace the outer flange and tighten the flange. Release the spindle
lock.
WARNING: only use wheels with maximum safe operating speed rated at or above the RPM listed on the
"WARNING"selection of the tool`s nameplate.This speed is based on the strength of the wheel,allowing for a
reasonable measure of safety,It is not meat to imply a best or most efficient operating speed ,Do not exceed the
Maximum Safe Operating Speed.
16. Dust-extraction system.
Dust released during the processing of materials such as paints containing lead, some wood, minerals and
metals can be hazardous to health. By skin contact or inhalation of such powders can cause allergic reactions
and / or respiratory illnesses to working with power tools or nearby persons. Certain powders, for example
released during the processing of beech and oak are considered to be carcinogenic, particularly in combination
with chemical treatment of wood (chromate, preservatives, etc.).. Where possible, use dust-extraction system.
Provide good ventilation in the workplace. Use of respiratory mask with a filter of class P2.
17. Working with angle grinders.
17.1. Beware of the voltage of the supply network! Supply voltage of the network must conform to the details
shown on the plate of power. Appliances marked with 230 V, can be supplied with a voltage of 220 V.
17.2. In the grinding power generators that do not have sufficient capacity, respectively. Have appropriate control
voltage to increase the starting current for inclusion can be observed a temporary drop in power or unusual
behavior of the grinding machine. Please make sure you use the generator is appropriate, especially in terms of
voltage and frequency.
17.3. Outdoor use.
Connect the machine only in installations equipped with electric switch Fi (safety shut-off switch with Residual
protection), and current leakage, which is triggered when Fi must be no more than 30 mA.
17.4. Swich on.
The angle grinder comes with a safety switch which is designed to prevent accidents. To switch on, push the slide
switch (2) to the right while at the same time pushing the ON/OFF switch (1) forwards and depressing. To switch
off the angle grinder, depress the button (1) at the back. The switch (1) will jump back into its starting position.
Check the working tools before using them. Work tools must be impeccably mounted and spinning without
touching anything. Leave it to rotate without a load test at least one minute. Do not use damaged, beating or