Installing The Detector - Agilent Technologies 1200 Infinity Series User Manual

Installing the Detector

Parts required #
1
1
1
Other cables see below and section
Software required Instant Pilot and/or one of the following software solutions for control and data evaluation with the
appropriate revisions:
1
2
3
Test and diagnostic software:
• Agilent LabAdvisor (B.01.03 SP4 or above)
Preparations Locate bench space
Provide power connections
Unpack the module
Module is partially energized when switched off, as long as the power cord is
WA R N I N G
plugged in.
Repair work at the module can lead to personal injuries, e.g. shock hazard, when the
cover is opened and the module is connected to power.
➔
➔
➔
Agilent 1200 Infinity Series DAD User Manual
Description
Detector
Power cord
LAN cable (cross-over or twisted pair network cable)
Agilent ChemStation for LC (B.04.02 DSP3 or above)
EZChrome Elite (3.3.2 SP2 or above)
MassHunter (B.04.00 and B.03.01 SP2 or above)
Make sure that it is always possible to access the power plug.
Remove the power cable from the instrument before opening the cover.
Do not connect the power cable to the Instrument while the covers are removed.
"Cable Overview" on page 192.
Installing the Module

Installing the Detector

3
41