Installing The Detector - Agilent Technologies Infinity 1260 User Manual

3
Installing the Refractive Index Detector

Installing the Detector

Installing the Detector

Parts required Description
Power cord
For other cables see
Hardware required Agilent 1260 Infinity Refractive Index Detector (G1362A)
Preparations • Locate bench space
• Provide power connections
• Unpack the detector
The detector is turned on when the line power switch is pressed and the green indicator
N O T E
lamp is illuminated. The detector is turned off when the line power switch is protruding and
the green light is OFF.
Module is partially energized when switched off, as long as the power cord is
WA R N I N G
plugged in.
Repair work at the module can lead to personal injuries, e.g. shock hazard, when the
cover is opened and the module is connected to power.
➔
➔
➔
The detector was shipped with default configuration settings. To change these settings see
N O T E
"Setting the 8-bit Configuration Switch (without On-Board LAN)"
1 Install the LAN interface board in the detector (if required), see
2 Place the detector in the stack or on the bench in a horizontal position.
56
"Cable Overview"
Make sure that it is always possible to access the power plug.
Remove the power cable from the instrument before opening the cover.
Do not connect the power cable to the Instrument while the covers are removed.
the Interface Board"
on page 146
on page 139.
on page 33.
Agilent 1260 Infinity RID User Manual
"Replacing