Table of Contents
Advertisement
Color of the blade length adjustment knob: Red
(PHP31-CB15-HS cutter pen for 1.5 mm blades)
(1) Remove holder (B) by turning the blade length adjustment knob in the
Holder (B)
(2) Remove the blade from holder (A).
(3) With the tip of holder (A) facing downward as shown, insert the new blade.
(4) Make sure the blade is inserted straight into the holder. If the blade is positioned
Plunger
(5) With the tip of holder (A) facing downward, attach the holder cap and then turn
(6) Using your finger, check that the cutter blade rotates smoothly inside the cutter
Holder (A)
(Inside plunger body)
(7) If the blade does not rotate smoothly or the blade falls off after attaching the cutter
CAUTION
Be careful not to stab your finger when handling the cutter blade.
Color of the blade length adjustment knob: Green
(PHP31-CB15B-HS cutter pen for 1.5 mm diameter blades fitted with a spring)
(1) Remove holder (B) by turning the blade adjustment knob in the counterclockwise
Holder (B)
(2) Remove the blade and the spring from holder (A).
(3) With the plunger held at an angle, and with the plunger cap pointing upward,
Plunger
Holder (A)
(4) Make sure that the blade is inserted straight into the plunger. If the blade is
(Inside plunger body)
(5) With the plunger still in the upright position, insert the holder cap until you hear it click into place. Turn
the blade adjustment knob in the clockwise direction to adjust the length of the blade.
CAUTION
Be careful not to stab your finger when handling the cutter blade.
FC2250-UM-251-9730
counterclockwise direction.
at an angle, gently tap the plunger to correct the orientation of the blade.
the blade length adjustment knob in the clockwise direction until the blade tip is
visible.
pen (be careful not to stab your finger at this time).
pen to the pen carriage, the inside of the holder is insufficiently lubricated.
In this case, apply the grease provided to the three points indicated by arrows in
the figure.
direction.
insert the blade with its spring attached into the plunger. Take care that the spring
does not fall off the blade.
inserted at an angle, gently tap the plunger to correct the orientation of the blade.
3-2
3. OPERATIONS
Advertisement
Table of Contents
