R&S NGA100 Series Getting Started page 22

®
R&S NGA100
For safety reasons, the instrument can only be operated with authorized safety
sockets.
The power cable must be plugged in before signal circuits can be connected.
Never use the product if the power cable is damaged. See
ing On the Instrument",
Ethernet connector (9)
This connector is used for establishing remote control via SCPI. See section
"Ethernet Setup" in the user manual for more information on the connection
setup.
USB connector (10)
The USB connector is a Type-B connector for remote control operation via USB
TMC or USB VCP.
Digital I/O connector (11)
The Digital I/O connector is a 5-pin terminal block for external trigger input or out-
put.
Measurement control can be achieved by means of an external input signal or as
an output signal to trigger other instruments for some measurements.
The Digital Trigger I/O option (NGA-K103) must be installed for this function to be
available in the instrument.
Rear panel connector (12)
Shock Hazard
Do not turn on AC power when connecting wires to the rear panel connec-
tor.
Tightened all wires connected to the terminal block.
Getting Started 5601.8902.02 ─ 06
on page 21 for more information.
Instrument Tour
Overview of Controls
Chapter 4.2, "Switch-
19