R&S NGA100 Series Getting Started page 25

®
R&S NGA100
2. Connect the power cable to the socket outlet.
3. Press [Power] key on the front panel.
The instrument performs a system check, boots the operating system and
starts the R&S NGA100 firmware.
By default, all output channels are turned off when the instrument is switched
on to prevent connected loads from being damaged unintentionally.
During startup, the R&S NGA100 is loaded with the last saved instrument set-
tings from memory location "M1" and auto saved parameters. See "Store and
Recall" in the User Manual.
To switch off instrument:
1. Press [Power] key.
2. Disconnect the AC power cable from the socket outlet.
Getting Started 5601.8902.02 ─ 06
Instrument Tour
Switching On the Instrument
22