Intended Operation - R&S NGA100 Series Getting Started

®
R&S NGA100
Exceeding the low voltage protection
Use insulated wires and not bare wires for the terminal connection.
For the series connection of all output voltages of the 35 V variant, it is pos-
sible to exceed the low voltage protection of 42 V. Please note that in this
case any contact with live components is life-threatening. It is assumed that
only qualified and trained personnel service the power supplies and the
connected loads.
Before switching on the product, it must be ensured that the nominal voltage set-
ting on the product matches the nominal voltage of the AC supply network. If it is
necessary to set a different voltage, the power fuse of the product must be
changed accordingly.
3.2

Intended Operation

The instrument is intended only for use by personnel familiar with the potential
risks of measuring electrical quantities.
For safety reasons, the instrument may only be connected to properly installed
safety socket outlets. Separating the ground is prohibited.
The power plug must be inserted before signal circuits may be connected.
Use only the power cord included in the delivery package. See
package" on page 13.
Before each measurement, measuring cables must be inspected for dam-
age and replaced if necessary. Damaged or worn components can damage
the instrument or cause injury.
The product may be operated only under the operating conditions and in the posi-
tions specified by the manufacturer, without the product's ventilation being
obstructed. If the manufacturer's specifications are not observed, this can result
in electric shock, fire and/or serious personal injury, and in some cases, death.
Getting Started 5601.8902.02 ─ 06
Putting into Operation
Intended Operation
"Delivery
11