R&S NGA100 Series Getting Started page 23

®
R&S NGA100
Output terminals
Either the output terminals at the front panel or the rear panel connector at
the back panel can be used.
Both terminals should not be used at the same time as it can cause the
instrument to malfunction.
The rear panel connector contains both output ("F+", "F-") and sense ("S+", "S-")
connections. Connector for "Ch 2" is only available in the NGA102, NGA142 mod-
els.
Kensington security slot (13)
A Kensington lock can be anchored to the R&S NGA100 power supply housing to
secure it to a workstation mechanically.
4.1.3 Bottom Panel
The voltage selector is located at the bottom panel. On your first power-on con-
nection, you should see a yellow label sticker attached over the
peeling off the yellow label sticker, make sure that the correct fuse rating is used
for the mains voltage.
Figure 4-3: Bottom panel of R&S NGA100
14 = Voltage selector
15 = Voltage selector label
Getting Started 5601.8902.02 ─ 06
Instrument Tour
Overview of Controls
AC inlet. Before
20