Table of Contents
Advertisement
1-12 HOW TO HANDLE THE VEHICLE
https://www.truck-manuals.net/
3
4
2
1
MTA0180
MTA0190
MTA0200
MTA0210
•
Windshield wiper switch
The windshield wiper switch has 3 positions to
control the windshield wiper.
1. OFF = Off
2. INT = Intermittent wipe
3. LO = Continuous wipe, slow speed
4. HI = Continuous wipe, fast speed
Caution
Do not operate the wipers when the windshield
remains dry. They may scratch the windshield glass.
Do not operate the wipers if they are covered with
snow or ice as this may damage the wiper system.
•
Wiper speed control switch
The desired intermittent operation time can be
controlled by turning the knob when the wiper
switch is in "INT" position.
•
Windshield washer switch
To let washer fluid spray on the windshield,
press and hold the center button of switch. And
the windshield wipers are simultaneously
operated for 2-3 cycles.
•
Exhaust brake switch
The exhaust brake system is designed to shut
off exhaust pipe when the engine brake is ap-
plied, resulting in assisting brake action. When
the switch lever is pushed downward, and clutch
and accelerator pedals are released, the indi-
cator lamp comes on showing that the ex-haust
brake is in operation. When the clutch and ac-
celerator pedals are depressed, the exhaust
brake stops working.
In the case of 24ton dump truck, this opera-
*
tion is done by using the Jake Brake switch.
For detail, refer to "Jake brake switch" .
•
Hazard warning flasher switch
When the right-hand lever is pushed upward,
all the turn signal lamps are made to flash
regardless of the turn signal switch position.
The hazard warning flasher switch is to be used
when your vehicle gets in a traffic hazard or is
parked in the darkness.
Advertisement
Table of Contents
Troubleshooting
