Daewoo Novus M2SEF Manual page 10

https://www.truck-manuals.net/
descending
position
Inside the cab
Hook
Lock
lever
MTA1240
(4) Cab is ascending while pushing the cab-tilt
switch. You can manipulate the switch to adjust
open angle of the cab as desired. Stop pushing
the switch when the cab is tilted over than the
cab weight center, if you keep pushing the
switch on the noise will be increased.
1. If you want to stop ascending the cab, you
should position the direction change lever in "D"
position.
MTA1220
2. Do not work without tilting the cab completly.
3. Do not start engine when the cab does not tilted
completly or while descending.
4. Never tilt the cab at a sloped hill.
5) How to lower the cab (Hydraulic cab latch :
option)
(1) Position the direction change lever in "D" posi-
tion.
(2) Press the switch as shown, and then the pump
works and the cab starts to descend.
(3) Once the cab descended completly, stop push-
ing the switch.
MTA1230
(4) Once the cab descends completely, check that
the lever located at the rear lower right hand
side of the cab is locked into hook.
For hydraulic cabin latch type vehicle, Make
sure that release cab tilt switch to "OFF" and
warning lamp is off before driving.
MTS0190
1. While driving you should set the direction change
lever in "D" position.
2. Be sure to check that the lock lever is locked in
hook. In the event of troubles with cab tilting sys-
tem, call for check and necessary services of your
nearest Daewoo dealer.
1-7 HOW TO HANDLE THE VEHICLE
Caution
Caution