Starting The Engine(Ddc) - Daewoo Novus M2SEF Manual

2-56 DRIVING
LOCK
https://www.truck-manuals.net/
MTB0191
MTB0192
ON
START
MTB0200

2) Starting the engine(DDC)

1. Don't step on accelerator pedal. ECM is not able
to recognize the idle status of engine.
2. Don't step on clutch pedal.
3. Turning the key position at'on' will light up
(yellow:Engine check indicator) and
(red:Engine stop warning) for 2 to 5 seconds.
Caution
1. Start the engine after the warning lamp goes out.
2. Warning lamp keeps coming on when engine
system has trouble. At this time, consult your
nearest Daewoo dealer for necessary services.
4. Turn the starter key to START position.
Caution
1. Make sure that transmission lever is in neutral
polsition with parking brake applied before stat-
ing the engine.
2. ECM automatically controls idling RPM, consid-
ering ambient air, oil, coolant temperature.
Manual adjustment is not necessary.
5. Pre/After heating system injects ether alcohol
into air intake system, mixed with diesel, results
in combustion.
Note
1. Ether alcohol is controlled by injection relay in-
side stowage in front of passenger seaat, injected
into intake manifold for 3 seconds for
preheating(In case of ambient temperature-40
degree in Celsius), for 30 seconds in maximum
for after-heating.
2. Idling RPM can rise up to 800-900 rpm when
engine is cold. Do not control idle speed knob as
white smoke is controlled by ECM(during 20
up to 40 seconds.)
CEL