How To Change Shaking Stroke On Sk-71 - Jeio tech Lab Companion SK-300 Operating Manual

How to change shaking stroke on SK-71

[Figure #1]
1. Loosen M5x8, flat head bolt(+, screw driver) from the shaking table(A).(See Figure #1)
2. Loosen M4x8, flat head bolt(+, screw driver) in the position of both side and back
side of body cover(B) to separate from the body.(See Figure #1)
3. Loosen 2 ea M5x15, wrench bolt(4mm, wrench handle) in the position of Bracket(C)& 2
ea 5mm knot(8mm, spanner)in the position of Bracket(D).(See Figure #2).
4. Loosen 4 ea M5x8, wrench bolt(4mm, wrench handle) in the position of Frame
Fixture(E).(See Figure #2)
Upper/Bottom Vibrating Frame
Body
Page 32
A. Shaking Table
B. Body cover
Shaking System Unit
[ Figure #3 ]
D. Bracket
F. RPM Sensor
STROKE 40mm
STROKE 30mm
E. Frame Fixture
C. Bracket
[Figure #2]
STROKE 50mm
STROKE 60mm
STROKE 70mm
[ Figure #4 ]