How To Change The Stroke Width Adjustment; How To Change Shaking Stroke On Sk-300, 600 - Jeio tech Lab Companion SK-300 Operating Manual

How to change the stroke width adjustment

How to change shaking stroke on SK-300, 600

[ Figure #1 ]
1) Loosen M5x10, wrench bolt (4mm, wrench handle)and then separate the shaking table(A).
(See Figure #1)
2) Loosen M4x8, flat head bolt(+, screw driver) in the position of both side of body
cover(B).(See Figure #1)
3) Loosen 2 ea M5x15, wrench bolt(4mm, wrench handle) in the position of Bracket(C)& 2
ea 5mm knot(8mm, spanner)in the position of Bracket(D).(See Figure #2).
4) Loosen 4 ea M5X12, wrench bolt(4mm, wrench handle) in the position of Frame
Fixture(E).(See Figure #2)
Upper/Bottom Vibrating Frame set
[ Figure #3 ]
A. Shaking Table
B. Body Cover
F. Position Sensor
Driving Wheel
D. Bracket
[ Figure #2 ]
STROKE 40mm
STROKE 30mm
[ Figure #4 ]
E. Frame Fixture
C. Bracket
STROKE 20mm
Page 29