Jeio tech Lab Companion SK-300 Operating Manual page 30

5) Take care and ensure that there will be separated parts Upper/Bottom Vibrating
Frame. There will be Drying wheel and RPM sensor in the Body.
6) Disassemble RPM Sensor (F), (+, screw driver) and then Fix it to the modified
Stroke. (See Figure #4).
G. Belt
H. Rotary Spin
7) After turning Rotary Spin Fin (H) in the position of Driving Wheel, There is 4 ea
M5 X 10mm,
Wrench bolt under the Hole. (See Figure #5)
8) Remove 4ea M5X10mm, wrench bolt (4mm, wrench handle). Rotary Spin Set (H) will be
separated.
9) Locate the position of the stroke fixture hole of the Driving Wheel Set.
(See Figure #6)
10) Fit and Fix out the rotary spin set into the stroke fixture hole after setting it
to the required position. The correct stroke length can either be 20, 30, 40mm.
11) Reinstall the shaking table into the unit in the reverse order.
Page 30
I. Wrench bolt
[Figure #5]
Rotary Spin Set
[Figure #6]
Stroke Fixture hole
Driving Wheel Set