How To Operate; Input Shaking Speed; Timer Programming; Time Programming - Jeio tech Lab Companion SK-300 Operating Manual

How to operate

Page 20

Input shaking speed

1. Press SHAKER/SET key.
2. Press UP/DOWN key.
 Input RPM.
3. Press Enter Button.
 Finish to set value.
Press START/STOP key.
4.
 Shaking starts in clockwise rotation.
※ Recall function of RPM value
- Previous RPM value starts if new RPM is set again.

Timer programming

1. Time Programming

- Programming time can not be done during shaking. So, stop shaking by
pressing START/STOP key and start programming.
1) Input total run time
1. Press SHAKER/SET key Twice.
 This section is for setting total run time.
 ¡run.H¡ shown on MODE display.
2. Press UP/DOWN Button to set Time and then press
ENTER key to store the value. (Max Input Time: 1~999
hours)
After setting the value, TIMER LED is on.
3. Press SHAKER/SET key.
 This section is for setting minute and seconds.
 ¡run.S¡ shown on MODE display
4. Press UP/Down key to set minute and seconds and then
press Enter key to store the value.
(Max Input Time: 10seconds~ 59 minutes 59 seconds)