Jeio tech Lab Companion SK-300 Operating Manual page 22

Time for
Pause
Condition to
set timer
Page 22
4) Programming Pause time
1. Press SHAKER/SET key.
 This section is for setting Pause.
 ¡PAu.S¡ shown on MODE display.
2. Press UP/DOWN key to set Time and then press ENTER
key to store the value.
(Max Input Time: 10 seconds~ 59 minutes 59 seconds)
3. If not use Pause function, do not press Enter Button.
5) Condition of Timer Programming
1.¡ Total program time¡ is the best standing.
After operating total program time¡, the shaker stops.
2. If not input time of F/Ward or B/Ward , the shaker
operates fixed
Button.
3. If input PAUSE Time, the shaker operates fixed RPM forward
pressing START/STOP Button.
before
RUN TIME: Total program time.
F/WARD: Clockwise
B/WARD: Anticlockwise
PAUSE:
temporarily.
Run Time value should be
bigger than
F/WARD, B/WARD and PAUSE
Time.
RPM before pressing
Press Enter button to omit the
function
B/WARD and PAUSE Time. The
value is not stored and then
press SHAKE/SET button to go
on next section.
Stop shaking
total time of
START/STOP
among F/WARD,