Completed Outdoor Sbu Ont Installation; Figure 2-4. Completed Installation - ADTRAN Total Access 300 Series Installation And Maintenance Manual

Completed Outdoor SBU ONT Installation

Figure 2-4
completely configured and installed in the Enclosure.
NOTE
This illustration omits the OptiTap connection. For Installation of the
OptiTap, refer to
612877SBONT-5B
displays the various wire routing and drops when the Electronics Module is
Note: Safety Cover has been
removed for illustration purposes.
Electronics
Module
Splice Tray
Fiber
Cable
Support
Clamp
Strength
Member
(Red)
Fiber In
Ground
Note:
When using the NID Housing,
ground the unit using the Ground
Lug attached to the Mounting Plate.

Figure 2-4. Completed Installation

"OptiTap Installation"
Section 2, Small Business Unit Installation - Installation
TOTAL ACCESS 372
1287722G1
TELEPHONE TROUBLESHOOTING:
1. Identify the bad line (POTS 1-8).
2. Plug any working phone into
the appropriate jack.
If the telephone works, the unit
is functioning normally.
If the telephone does not work,
contact your service provider.
3. Remove the telephone from the
POTS jack.
N T E R F
Power
on page 2-24.
Note: The RJ-11 POTS
ports are used for test
purposes only.
Tip (Green)
Ring (Red)
Fiber Jumper
Cable (Yellow)
DS1
Connection (Red)
Ethernet
Connection (White)
Coaxial Connection
SC/APC Connector
Note: Cable color is for
clarity purposes only.
2-9