Mounting The Electronics Module Indoors; Figure 2-17. Indoor Mounting - ADTRAN Total Access 300 Series Installation And Maintenance Manual

Total Access 300 Series Small Business Unit ONT Installation and Maintenance Guide

Mounting the Electronics Module Indoors

NOTE
The Electronics Module must be installed in a Restricted Access location.
To install the Electronics Module indoors, refer to
1. Choose a vertical surface near an approved ground.
2. Attach a 3/4 inch mounting board (typically plywood) to the wall studs using four, 2.5
3. Use the two keyholes on the reverse of the Electronics Module as location marks and
4. Slide the Electronics Module over the Pan Head screws and exert a small amount of
5. Lock the Electronics Module in place with a #6 Pan Head screw through the slot on the
6. Attach the Grounding Wire to the Ground Lug and secure using the Ground Lug Nut.
7. When Using the OptiTap Connector, refer to
2-26
inch or greater wood screws. (This provides long-term stability for the module.)
install two #6 Pan Head screws (1 inch or longer). Leave approximately 1/16 inch
protruding from the mounting surface.
downward pressure to ensure that the top of the slots are resting on the shafts of the
screws.
bottom of the Electronics Module.
Do not over tighten.
page 2-28, and secure the OptiTap Mounting Bracket to the surface using two, #4 wood
screws.
Plywood
Mounting
Surface
Ground Lug
Screw Slot
Figure 2-17
Figure 2-15
Screws (2)
TOTAL ACCESS 372R
1287722G2
TELEPHONE TROUBLESHOOTING:
1. Identify the bad line (POTS 1-8).
2. Plug any working phone into
the appropriate jack.
If the telephone works, the unit
is functioning normally.
If the telephone does not work,
contact your service provider.
3. Remove the telephone from the
POTS jack.
N T E
RF

Figure 2-17. Indoor Mounting

and the following instructions:
on page 2-24 and Figure 2-19
612877SBONT-5B
on