EDAN SE-601 Series User Manual page 19

SE-601 Series Electrocardiograph User Manual
I PRINT/STOP
J 1mV/COPY
K RESET
L MODE
Space/Feed
M
paper
N Tab
O Esc
P Power On/Off
Press to start or stop printing reports
Pressing Shift + PRINT/STOP can quickly enable or disable the print out
function in the auto or rhythm mode.
In the manual mode, pressing the 1mV/COPY key can insert a 1mV
calibration mark during the printing course.
In the auto or rhythm mode, pressing the 1mV/COPY key can print the
ECG report which was printed out last time.
A large polarization voltage may cause baseline drift. On the main
screen, pressing RESET can decrease the polarization voltage and draw
the baseline to zero quickly.
Press to select a working mode among the auto, manual, rhythm and
R-R analysis modes.
NOTE: Only if more than one working mode is selected in the Work
Mode Setup window, can the working mode be selected by
pressing the MODE key when the main screen is displayed.
Press to add a space between typed characters or select/deselect a
checkbox.
Press to feed paper:
If Paper Marker is set to Yes, pressing Tab can advance the recorder
paper to the next black marker; if Paper Marker is set to No, pressing
Tab can advance the paper for 2.5cm. Pressing Tab again can stop
advancing the paper.
Press to move the cursor:
Pressing Tab can move the cursor forward, and pressing Shift + Tab can
move the cursor backward.
In the manual mode or on the previewing screen, press this key to switch
the lead groups.
Press to cancel operation
Power-on/Power-off
- 13 -
Introduction