Target Counting - Vitek Transcendent VTC-TNB8RFA3-2 Manual

Network Camera User Manual
as schedule recording setup (See Schedule Recording).
* The configuration requirements of camera and surrounding area are the same as intrusion
detection

4.5.6 Target Counting

This function is to calculate the number of people or vehicles crossing the alarm line through
detecting, tracking and counting the shapes of people or vehicles.
1. Go to Config→Event→Target Counting as shown below.
2. Enable target counting and select the snapshot type and the detection target.
Save Panoramic Picture: If it is enabled, the detected panoramic pictures will be captured and
saved to the SD card when the targets cross the pre-defined alarm line.
Save Target Cutout: If it is enabled, the detected target cutout pictures will be captured and
saved to the SD card when the targets cross the pre-defined alarm line.
Note: To save snapshots to the local PC, please enable "Local Smart Snapshot Storage" in the
local config interface first. To save snapshots to the SD card, please install an SD card first.
Detection Target: Select the target to calculate. Human, Motor Vehicle and
Motorcycle/Bicycle can be selected.
Counting Reset: The current number of the target counting can be reset. You can choose to
reset the counting daily, weekly or monthly. Click "Reset" to manually reset the current number
of crossing line people/car/bike counting.
3. Set the area of the target counting. Click the "Area" tab to go to the interface as shown
below.
37