Alarm In; Alarm Out - Vitek Transcendent VTC-TNB8RFA3-2 Manual

8mp ip camera series transcendent series 8 megapixel [4k] ip cameras with matrix ir and gen. iii advanced analytics

Table of Contents

Network Camera User Manual

2. Click "Enable" and set the alarm holding time.

3. Trigger alarm out. When the camera is disconnected, the system will trigger the alarm out.

4.4.3 Alarm In

This function is only available for some models. To set sensor alarm (alarm in):

Go to Config→Alarm→ Alarm In interface as shown below.

1. Click "Enable" and set the alarm type, alarm holding time and sensor name.

2. Set alarm trigger options. The setup steps are the same as motion detection. Please refer to

motion detection

chapter for details.

3. Click "Save" button to save the settings.

4. Set the schedule of the sensor alarm. The setup steps of the schedule are the same as the

schedule recording setup. (See

Schedule

Recording).

This function is only available for some models. Go to Config→Alarm→Alarm Out.

Table of Contents