Vitek Transcendent VTC-TNB8RFA3-2 Manual page 31

Network Camera User Manual
2. Click "Enable" and set the alarm holding time.
3. Set alarm trigger options. Trigger alarm out, Email and FTP. The setup steps are the same
as motion detection. Please refer to
⚫ IP Address Conflict
This function is only available for the models with Alarm Out interface.
1. Go to Config Alarm
→
2. Click "Enable alarm" and set the alarm holding time.
3. Trigger alarm out. When the IP address of the camera conflicts with the IP address of other
devices, the system will trigger the alarm out.
⚫ Cable Disconnection
This function is only available for the models with Alarm Out interface.
1. Go to Config Alarm
→
motion detection
Anomaly IP Address Collision as shown below.
→ →
Anomaly Cable Disconnected as shown below.
→ →
chapter for details.
25