Image Configuration - Vitek Transcendent VTC-TNB8RFA3-2 Manual

Network Camera User Manual
"Add": Add the schedule for a special day. Drag the mouse to set the time on the timeline.
"Erase": Delete the schedule. Drag the mouse to erase the time on the timeline.
Manual Input: Click it for a specific day to enter specific start and end times.
Day schedule
Set the alarm time for alarm on a special day, such as a holiday.
Note: Holiday schedule takes priority over weekly schedule.
⚫ Snapshot Settings
Go to Config System Storage Snapshot to go to the interface as shown below.
→ → →
Set the format, resolution and quality of the image saved on the SD card and the snapshot
interval and quantity and the timing snapshot here.
Snapshot Quantity: The number you set here is the maximum quantity of snapshots. The actual
quantity of snapshots may be less than this number. Supposing the occurrence time of an alarm
event is less than the time of capturing pictures, the actual quantity of snapshots is less than the
set quantity of snapshots.
Timing Snapshot: Enable timing snapshot first and then set the snapshot interval and schedule.
The setup steps of schedule are the same as the schedule recording (See Schedule Recording).

4.2 Image Configuration

Image Configuration includes Display, Video/Audio, OSD, Video Mask and ROI Config.
14