Vitek Transcendent VTC-TNB8RFA3-2 Manual page 40

Network Camera User Manual
1. Enable region entrance detection and select the snapshot type and the detection target.
Save Panoramic Picture: If it is enabled, the detected panoramic pictures will be captured and
saved to the SD card when the targets enter the pre-defined areas.
Save Target Cutout: If it is enabled, the detected target cutout pictures will be captured and
saved to the SD card when the targets enter the pre-defined areas.
Note: To save snapshots to the local PC, please enable "Local Smart Snapshot Storage" in the
local config interface first. To save snapshots to the SD card, please install an SD card first.
Detection Target:
Human: Select it and then alarms will be triggered if someone enters the pre-defined area.
Motor Vehicle: Select it and then alarms will be triggered if a vehicle with four or more wheels
(eg. a car, bus or truck) enters the pre-defined area.
Motorcycle/Bicycle: Select it and then alarms will be triggered if a vehicle with two wheels
(eg. a motorcycle or bicycle) enters the pre-defined area.
All of the three types of objects can be selected simultaneously. Please select the detection
objects as needed. If no object/target is selected, alarms will not be triggered even if region
entrance detection is enabled.
2. Set the alarm holding time.
3. Set alarm trigger options. The setup steps are the same as motion detection. Please refer to
motion detection chapter for details.
4. Click the "Save" button to save the settings.
5. Set the alarm area of the region entrance detection. Click the "Area" tab to go to the
interface as shown below.
34