Status Information; Status Display On The Bamocar - Unitek BAMOCAR-PG-D3-400/400 Manual

Status information

5 Status information
In the "Normal" state, the green 7-segment display plus decimal point lights up as an operating
indicator (status display).
In the "Error" state, the red error LED lights up and the green 7-segment display indicates the error
number.
In the "Warning" state, the red error LED flashes and the green 7-segment display alternates between
the status and the warning number.
5.1

Status display on the BAMOCAR

Display Dot/ dash
flashes
dark
flashes
lights up
dark
lights up
lights up
lights up
flashes
lights up
dark
lights up for
0,1 s
Example: Motor clockwise
Dot flashes
Bottom line
Right line
Version: 2021 / V2
State
Processor active
Auxiliary voltage missing or unit-internal hardware
error
Start status after reset (auxiliary voltage 24V off-on)
The first release ends the flashing state
Drive enabled
Drive locked (not enabled)
Speed equal to zero (message standstill)
Drive turns right, N currently positive
Drive turns left, N currently negative
Motor current reduced to continuous current Icns
Motor current at maximum current limit Imax
Normal operation, motor current within the current
limit
A new command (value) has been received from the
BUS or RS232.
= Processor active
= Drive enabled
= Motor turns right
Page: 46
Status at NDrive
OK = 0
OK = 1, ENA = 1
OK = 1, ENA = 0
N0 = 1
N0 = 0
N0 = 0
Icns = 1
Icns = 0
Icns = 0
BAMOCAR-PG-D3-700/250, 400