Rotor Position Sensor Connection With Bl Tacho - Unitek BAMOCAR-PG-D3-400/400 Manual

Control ports

4.12 Rotor position sensor connection with BL tacho

Only for BAMOCAR-PG-D3-BL
3 rotor position sensor signals (Hall
sensors) for commutation.
With or without brushless tacho-
generator.
The rotor position sensor is galvanically
connected to the device zero (GND).
Supply voltage 15 V from servo.
Adaptor if the tachometer voltage at
nominal speed is greater than 10 V~.
For smaller tachometer voltages
X7: Connect pin 1, 9 and 11.
Connect tacho centre to X7:1.
Connector
Encoder plug bl
X7
A MP speedometer
B
C Speedometer 1
D Supply +15 V
E Speedometer 2
F
G Speedo 3
H Temp Signal
J Temp GND
K Rotor position 3
L Supply GND
M Rotor position 2
N
O Rotor position 1
P
Only use motors with rotor position sensor (BL) approved by the manufacturer.
Connector plug
Connection cable
Cable length
Shield connection
Setting parameters
Version: 2021 / V2
X7
7 x signal wires
2 x supply wires
2 x temperature veins
Use only suitable cable for drag chain.
for > 25 m cross-section one step larger.
at connector X7
on the motor plug
see software manual NDrive
Page: 45
19-pin round plug
Minimum cross section 0.25 mm
Contact the shield with the
connector housing.
Contact the shield with the
connector housing.
BAMOCAR-PG-D3-700/250, 400