Configuration; Ethernet Settings - ICP DAS USA ET-7000 Series User Manual

Chapter 3 Web Configuration Page

3.2. Configuration

3.2.1. Ethernet Settings

The Ethernet settings page can be used to view and change the TCP/IP network settings for
the ET-7000 module.
Settings
4-byte IP address. Each ET-7000 module
IP needs an IP address so that if can be
identified on the network
4-byte Gateway. A gateway is a network
address that acts as an entrance to
another network. Usually, computers that
Gateway
control the traffic within the network or at
the local Internet Service Provider (ISP)
are gateway nodes.
4-byte subnet Mask. A subnet mask
represents all the network hosts at one
geographic location on the same local
area network. When an Ethernet packet is
Mask
sent across the network, the ET-7000 will
use the subnet Mask to check whether
the TCP/IP host specified in the packet is
on local network segment.
Select this option If there is a DHCP
server on the network, the server can
DHCP
assign the IP address automatically.
Firmware Version and Date
Firmware Ver.
MiniOS7 Version and Date
MiniOS7 Ver.
ET-7000 AIO User Manual, Apr. 2009, V1.04,
Table 3-1 TCP/IP network settings
Description Range
X.X.X.1
To
X.X.X.254
X.X.X.0
To
X.X.X.254
X.X.X.0
To
X.X.X.255
0 (Disable)
1(Enable)
Varies depending
N/A
Varies depending
N/A
EMH-011-104----------61
Factory default
192.168.255.1
192.168.0.1
255.255.0.0
0 (Disable)
on the Module
on the Module