ICP DAS USA ET-7000 Series User Manual page 24

Chapter 1 Introduction


Name
Run
LINK/ACT
10/100M
Note:
If the Run LED does not display the information as above, the following steps should be
taken:
Switch the Power off
Check that the Init/Normal switch is in the Normal position. (Refer to Back Panel
Description)
Switch the Power on and double-check the LED indicators.
J1 Connector
Refer to Sec.1.3 Module Selection for more details regarding the pin assignments of the
J1 Connector for all types of ET-7000 series modules.
J2 Connector
Pin number
8
9
ET-7000 AIO User Manual, Apr. 2009, V1.04,
Table 1-2 LED Indicators
LED Action
Flashing
ON
OFF
Flashing Green
OFF
Orange
Table 1-3 J2 Connector
Name
+VS
GND
Function
Firmware is running
Ethernet link detected
No Ethernet link detected
Ethernet packet received
Speed 10 Mbps
Speed 100 Mbps
The definition of pin8 and pin9 applies
to all types of the ET-7000 modules.
The definition of the other pins is
dependent on the particular ET-7000
modules.
Function
10 ~ 30 V power input
DC
Ground connection
EMH-011-104----------24