Authentication; Account Management - ICP DAS USA ET-7000 Series User Manual

Chapter 3 Web Configuration Page

3.3. Authentication

3.3.1. Account management

Each ET-7000 series module provides access privilege for up to five user accounts including a
default Admin account and four general user-defined accounts. Each of the user-defined
accounts can be assigned either Admin or general user privilege. Assigning Admin privilege
allows the account to read and write configuration settings but the general user account is
restricted to read only access. The maximum number of characters that can be used for an
account name is 8.
Each of the account requires password authentication. The maximum number of characters
allowed for the password is 8.
Load Setup Defaults: Load the factory default Account management settings. All current
accounts will be deleted, except the Admin account, and the password of Admin account will
revert to "Admin".
Press the
Notes:
The default account is called "Admin" and the password is also "Admin". The
password and the Admin account can be changed, but the account name cannot be
changed or deleted.
If you forget the password for the Admin account, the ONLY way to configure the ET-
7000 is by using the "Reset to Factory default" option. (Please refer to Load All Setup
Default on Sec. 3.2.3 for more information)
ET-7000 AIO User Manual, Apr. 2009, V1.04,
button to enable the settings to take effect.
EMH-011-104----------73