Disable Led Blinking Or Turn Off Leds - NETGEAR WiFi 6 AX1800 User Manual

WiFi 6 AX1800 Dual Band Wireless Access Point WAX204
6. Click the Apply button.
Your settings are saved and the AP is reconfigured in the new system mode.

Disable LED blinking or turn off LEDs

The LEDs on the top panel of the AP indicate activities and behavior. By default, the
Internet LED, LAN LED, and WiFi LED blink when the AP detects data traffic. You can
disable LED blinking for data traffic, or turn off all LEDs except the Power LED.
To disable LED blinking or turn off the LEDs:
1. Connect your computer or mobile device to the AP in one of the following ways
• Connect directly to the AP's WiFi network or LAN. (Applies to the AP in either
operation mode.)
• Connect to the same network that the AP is connected to. (Applies only if the AP
is operating in AP mode.)
2. Launch a web browser and enter http://www.routerlogin.net in the address field.
Instead, if you are connected to same network as the AP, enter the LAN IP address
that is assigned to the AP. For information about finding the IP address, see Find the
IP address of the AP when you cannot use routerlogin.net on page 32.
A login window displays.
If your browser displays a security warning, dismiss the warning. For more information,
see Dismiss a browser security warning on page 38.
3. Enter the AP local device password.
The local device password is the one that you specified. The local device password
is case-sensitive.
The BASIC Home page displays.
4. Select ADVANCED > Advanced Setup > LED Control Settings.
The LED Control Settings page displays.
By default, the first radio button is selected, which allows standard LED behavior.
For more information about LEDs, see Top panel with LEDs on page 17.
5. Do one of the following:
• Disable blinking. To disable blinking, select the Disable blinking on Internet
LED, LAN LED, Wireless LED when data traffic is detected radio button.
Maintain and Monitor 168 User Manual