NETGEAR WiFi 6 AX1800 User Manual page 144

WiFi 6 AX1800 Dual Band Wireless Access Point WAX204
CAUTION: The following process erases all settings that you configured in the AP.
To erase the settings:
1. Connect your computer or mobile device to the AP in one of the following ways
• Connect directly to the AP's WiFi network or LAN. (Applies to the AP in either
operation mode.)
• Connect to the same network that the AP is connected to. (Applies only if the AP
is operating in AP mode.)
2. Launch a web browser and enter http://www.routerlogin.net in the address field.
Instead, if you are connected to same network as the AP, enter the LAN IP address
that is assigned to the AP. For information about finding the IP address, see Find the
IP address of the AP when you cannot use routerlogin.net on page 32.
A login window displays.
If your browser displays a security warning, dismiss the warning. For more information,
see Dismiss a browser security warning on page 38.
3. Enter the AP local device password.
The local device password is the one that you specified. The local device password
is case-sensitive.
The BASIC Home page displays.
4. Select ADVANCED > Administration > Backup Settings.
The Backup Settings page displays.
5. Click the Erase button.
A warning page displays.
6. Click the Yes button.
The configuration is reset to factory default settings. When the reset is complete,
the AP reboots. This process takes about two minutes.
WARNING: To avoid the risk of corrupting the firmware, do not interrupt the reset.
For example, do not close the browser, click a link, or load a new page. Do not turn
off the AP. Wait until the AP finishes restarting. If you can see the AP, the Power LED
turns solid green when the AP finishes restarting.
Maintain and Monitor 144 User Manual