Add An Ipv4 Static Route - NETGEAR WiFi 6 AX1800 User Manual

WiFi 6 AX1800 Dual Band Wireless Access Point WAX204

Add an IPv4 static route

You can add an IPv4 static route to a destination IP address and specify the subnet mask,
gateway IP address, and metric.
To add an IPv4 static route:
1. Connect your computer or mobile device to the AP in one of the following ways
• Connect directly to the AP's WiFi network or LAN. (Applies to the AP in either
operation mode.)
• Connect to the same network that the AP is connected to. (Applies only if the AP
is operating in AP mode.)
2. Launch a web browser and enter http://www.routerlogin.net in the address field.
Instead, if you are connected to same network as the AP, enter the LAN IP address
that is assigned to the AP. For information about finding the IP address, see Find the
IP address of the AP when you cannot use routerlogin.net on page 32.
A login window displays.
If your browser displays a security warning, dismiss the warning. For more information,
see Dismiss a browser security warning on page 38.
3. Enter the AP local device password.
The local device password is the one that you specified. The local device password
is case-sensitive.
The BASIC Home page displays.
4. Select ADVANCED > Advanced Setup > Static Routes.
The Static Routes page displays.
5. Click the Add button.
The Static Routed page adjusts.
6. In the Route Name field, enter a name for the route.
The name is for identification purposes.
7. To make the route private, select the Private check box.
A private static route is not reported in RIP.
8. To prevent the route from becoming active after you click the Apply button, clear
the Active check box.
In some situations, you might want to set up a static route but keep it disabled until
a later time. By default, the Active check box is selected and a route becomes active
after you click the Apply button.
Network Settings 123 User Manual