NETGEAR WiFi 6 AX1800 User Manual page 128

WiFi 6 AX1800 Dual Band Wireless Access Point WAX204
CAUTION: Unless you are comfortable with advanced network configurations, be sure
to follow the directions of your ISP. Incorrect configuration might cause the Internet
connection of the AP to go down.
To set up a bridge for a VLAN tag group and enable the new VLAN tag group:
1. Launch a web browser from a computer or mobile device that is connected to a WiFi
network or LAN port on the AP.
2. Enter http://www.routerlogin.net in the address field.
A login window displays.
If your browser displays a security warning, dismiss the warning. For more information,
see Find the IP address of the AP when you cannot use routerlogin.net on page 32.
3. Enter the AP local device password.
The local device password is the one that you specified. The local device password
is case-sensitive.
The BASIC Home page displays.
4. Select ADVANCED > Advanced Setup > VLAN / Bridge Settings.
The VLAN / Bridge Settings page displays.
5. Select the Enable VLAN / Bridge group check box.
The page expands.
6. Select the By VLAN tag group radio button.
The page adjusts and the default VLAN tag group displays.
7. To add a custom VLAN tag group, do the following:
a. Click the Add button.
The Add VLAN Rule page displays.
b. Specify the settings in the following fields:
• ISP Profile. This menu applies only to certain ISPs. If this option does not
apply, the menu is set to Others.
• Name. Enter a name for the VLAN tag group.
The name is for identification purposes.
• VLAN ID. Enter an ID from 1 to 4094.
• Priority. Enter a value from 0 to 7.
c. Select the check box for the LAN port (Port 1, Port 2, Port 3, or Port 4) or WiFi
network (Wireless1, Wireless2, or Wireless2) to which the device that must
circumvent the AP's NAT service is connected.
Network Settings 128 User Manual