NETGEAR WiFi 6 AX1800 User Manual page 214

WiFi 6 AX1800 Dual Band Wireless Access Point WAX204
The Port Forwarding / Port Triggering page displays.
6. Make sure that the Port Forwarding radio button is selected.
7. Click the Add Custom Service button.
The Ports - Custom Services page opens.
8. Set up a new port forwarding rule for a custom service or application by specifying
the following settings:
• Service Name. Enter the name of the custom service or application.
• Service Type. Select the protocol (TCP or UDP) that is associated with the service
or application. If you are unsure, select TCP/UDP.
• External port range. If the service or application uses a single port, enter the
port number in the External port range field. If the service or application uses
a range or ranges of ports, specify the range in the External port range field.
Specify one range by using a hyphen between the port numbers. Specify multiple
ranges by separating the ranges with commas.
• Internal port range. Specify the internal port or ports by one of these methods:
-
If the external and internal port or ports are identical, leave the Use the same
port range for Internal port check box selected.
- If the service or application uses a range or ranges of ports, clear the check
box and specify the range in the Internal port range field. Specify one range
by using a hyphen between the port numbers. Specify multiple ranges by
separating the ranges with commas.
• Internal IP address. Either enter an IP address in the Internal IP address field
or select the radio button for a currently attached device that is listed in the table.
9. Click the Apply button.
Your settings are saved. The rule is added to the table on the Port Forwarding / Port
Triggering page.
10. To sort the table by internal IP addresses, click the Arrange By Internal IP button.
Port Forwarding and Port
Triggering [Router Mode]
214 User Manual