NETGEAR WiFi 6 AX1800 User Manual page 27

WiFi 6 AX1800 Dual Band Wireless Access Point WAX204
12. Click the Apply button, and in the pop-up window that displays, click the OK button.
Your settings are saved and the AP is reconfigured in AP mode, and is assigned a
new IP address by your routing device. In AP mode, the routing functions of the AP
are masked out in the local browser UI.
If you are connected over WiFi, your connection might be terminated.
13. If you were connected over WiFi and your connection was terminated, reconnect to
the AP.
14. Close and then reopen your browser, and enter http://www.routerlogin.net in the
address field.
The login window displays again.
If the login window does not display and your browser displays a security warning,
dismiss the warning. For more information, see Dismiss a browser security warning
on page 38.
If you experience connectivity problems, see You cannot log in to the AP [access
point mode] on page 233.
15. Enter your local device password.
The BASIC Home page displays.
16. Find the new IP address of the AP in the local browser UI by doing the following:
a. Select ADVANCED > ADVANCED Home.
The ADVANCED Home page of the AP displays. The Router Port pane shows the
LAN IP address that is now assigned to the AP.
b. Save the LAN IP address of the AP for later use.
You must use this IP address if you plan to connect to the same network as the
AP but not directly to the AP network. For example, use this IP address if you
connect over the LAN to the AP.
If you are directly connected to the AP over a WiFi connection or Ethernet
connection to one of the LAN ports, you still can use http://www.routerlogin.net.
17. If you are using the AP in a country other than the U.S. or Canada (where the region
is set and you cannot change it), set the country or region where you are using the
AP by doing the following:
a. Select Advanced > Advanced Setup > Wireless Settings.
b. From the Region menu, select the country or region where you are using the AP.
Note: Make sure that the country is set to the location where the device is
operating. You are responsible for complying with the local, regional, and national
regulations for channels, power levels, and frequency ranges.
Installation and Initial Log-in 27 User Manual