Add, Remove, Or Change A Device On The Blocked List - NETGEAR WiFi 6 AX1800 User Manual

WiFi 6 AX1800 Dual Band Wireless Access Point WAX204
7. To remove a device from the allowed list, do the following:
a. Select the check box for the device.
b. Click the Remove from the list button.
The device is removed from the allowed list.
8. To change the MAC address or name for a device on the allowed list, do the
following:
a. Select the check box for the device.
b. Click the Edit button.
The Edited Allowed Device page displays.
c. Change the MAC address, device name, or both.
d. Click the Apply button.
The Access Control page displays again.
9. Click the Apply button.
Your settings are saved.

Add, remove, or change a device on the blocked list

If you set up an access list that allows all new devices to access your network but you
want to block some devices, you must set up a blocked list that defines which WiFi and
wired devices are blocked from accessing your network. You do so by adding the MAC
addresses of these devices to the blocked list. You can also change or remove a device
from the blocked list.
To add, remove, or change a device on the blocked list:
1. Connect your computer or mobile device to the AP in one of the following ways
• Connect directly to the AP's WiFi network or LAN. (Applies to the AP in either
operation mode.)
• Connect to the same network that the AP is connected to. (Applies only if the AP
is operating in AP mode.)
2. Launch a web browser and enter http://www.routerlogin.net in the address field.
Instead, if you are connected to same network as the AP, enter the LAN IP address
that is assigned to the AP. For information about finding the IP address, see Find the
IP address of the AP when you cannot use routerlogin.net on page 32.
A login window displays.
Security, Firewall, and Access
Rules
90 User Manual