NETGEAR WiFi 6 AX1800 User Manual page 61

WiFi 6 AX1800 Dual Band Wireless Access Point WAX204
The local device password is the one that you specified. The local device password
is case-sensitive.
The BASIC Home page displays.
4. Select ADVANCED > Advanced Setup > IPv6.
The IPv6 page displays.
5. From the Internet Connection Type menu, select PPPoE.
The page adjusts. The AP automatically detects the information in the following
fields:
• Router's IPv6 Address on WAN. This field shows the IPv6 address that is acquired
for the AP's WAN (or Internet) interface. The number after the slash (/) is the length
of the prefix, which is also indicated by the underline (_) under the IPv6 address.
If no address is acquired, the field displays Not Available.
• Router's IPv6 Address on LAN. This field shows the IPv6 address that is acquired
for the AP's LAN interface. The number after the slash (/) is the length of the prefix,
which is also indicated by the underline (_) under the IPv6 address. If no address
is acquired, the field displays Not Available.
6. If already you set up your IPv4 ISP connection for PPPoE and want to use the same
login information for IPv6, select the Use the same Login information as IPv4
PPPoE check box and go to Step 8.
7. To manually configure the PPPoE settings for IPv6, specify the following settings:
• Login. Enter the login name that your ISP gave you.
• Password. Enter the password for the ISP connection.
• Service Name (if Required). Enter a service name. If your ISP did not provide a
service name, leave this field blank.
Note: The default setting of the Connection Mode menu is Always On to provide
a steady IPv6 connection. The AP never terminates the connection. If the connection
is terminated, for example, when the modem is turned off, the AP attempts to
reestablish the connection immediately after the PPPoE connection becomes available
again.
8. Select an IPv6 Domain Name Server (DNS) Address radio button:
• Get Automatically from ISP. Your ISP uses DHCP to assign your DNS servers.
Your ISP automatically assigns these addresses.
• Use These DNS Servers. If you know that your ISP requires specific servers, select
this option. Enter the IP address of your ISP's primary DNS server. If a secondary
DNS server address is available, enter it also.
Manually Set Up Internet
Settings [Router Mode]
61 User Manual