Table of Contents
Advertisement
5.
Connect a multimode fiber optic cable from the Output port of the transmitter to the Input port of the receiver
The transmitter and receiver front panel Link LEDs will light steadily (
6.
If appropriate, choose a location and mount the transmitter and receiver
•
For rack mounting, fasten the enclosure to the rack or rack shelf.
•
For furniture mounting, see
•
For table mounting, attach the provided four rubber feet to the bottom of the unit and place it where desired.
7.
Power on the host computer. On the transmitter, the Host and Link LEDs (
transmitter, and when the transmitter and receiver are connected with each other.
8.
Connect up to two USB peripheral devices (such as a camera, keyboard, touchpanel or printer) to the receiver USB ports
(figure 4,
6
).
The system is now ready to operate.
Front Panel Features
Transmitter – UCS FT 901
6
STATUS
LINK
HOST
e
UCS FT 901
A
Figure 6.
Transmitter Front Panel
—
A
Power LED
This green LED lights to indicate that the unit is receiving power.
—
B
Host LED
This green LED lights when the transmitter is powered, and communicating with the host PC.
SS 5G
POWER
—
C
Link LED
This green LED lights when the transmitter and receiver are connected by a fiber optic cable, receiving power.
12V
0.1A MAX
USB-C
HOST
OUTPUT
A
B
ZipClip 100 and 200 Mounting Installation
Receiver – UCS FR 902
C
e
A
B
Figure 7.
Tx
Rx
POWER
12V
1.6A MAX
C
figures 6
B
and
STATUS
LINK
C
Receiver Front Panel
1.5 A
1
2
DEVICES
A
D
C
and 7,
).
on the next page.
C
) light when the computer recognizes the
(figure
4,
5
).
UCS FR 902
Tx
Rx
INPUT
C
5
Advertisement
Table of Contents
