Table of Contents
Advertisement
UCS FT 901 and FR 902 • User Guide (Continued)
Cabling and Setup
Figure 4 shows connections for the UCS FT 901 and UCS FR 902.
Laptop
USB
Transmitter
SS 5G
4 4 4
Tx
POWER
12V
0.1A MAX
USB-C
HOST
OUTPUT
Compatible with USB 3.2
3 3 3
host ports ONLY
G
Ground
+12 VDC input
Figure 4.
Transmitter and Receiver Connection with Two External Power Supplies
Installation Procedure
ATTENTION:
Installation and service must be performed by authorized personnel only.
•
L'installation et l'entretien doivent être effectués uniquement par un technicien qualifié.
•
To ensure proper operation, the transmitter, receiver, USB host, and USB peripherals must be connected properly and in the
sequence described here (see figure 4).
1.
Power off all devices that will be directly connected to the receiver.
2.
Wire each of the two provided power supplies to their 2-pole captive screw connectors (see figure 5).
7/8"
(22 mm)
Heat
1/8"
Shrink
(3 mm)
3/16"
(5 mm) Max.
Figure 5.
Wiring the Power Connector for the UCS FT 901 and FR 902
NOTE:
The UCS FT 901 (transmitter) can also be powered by the host device, without the need for the external power
supply.
3.
Plug the two power supply connectors into their respective transmitter or receiver rear panel connectors (see figure 4,
Connect the 6 Watt power supply (
The green Power LED (see
powered on.
4.
Connect a USB Type A-to-C or Type C-to-C cable from the host device to the transmitter Host port (
figure 6
(
,
B
) will light, indicating that communication between the transmitter and host device has been established.
4
Multimode Fiber Optic Cable
5 5 5
Rx
Ground all
Devices
External Power Supply
1 1 1
(12 VDC, 0.5 A max.)
Captive Screw Connector
Tie Wrap
1
) to the transmitter, and the 24 Watt (
figure
6,
A
, on the next page) on the front panel of each device lights when each device is
USB Camera
USB
Receiver
POWER
POWER
6 6 6
1.5 A
POWER
12V
12V
12V
1.0A MAX
1.0A MAX
1
2
1.6A MAX
DEVICES
Compatible with USB 3.2, 2.0, 1.1
3 3 3
peripheral devices
Ground all
Devices
Ground
G
+12 VDC input
2
) to the receiver.
5 5 5
Tx
Rx
1
1
2
2
4
4
INPUT
2 2 2
External Power Supply
(12 VDC, 2.0 A max.)
3
).
4
). The Host LED
Advertisement
Table of Contents
