Front Panel Features; Transmitter Front Panel - Extron electronics FOX T USB User Manual

Front Panel Features

Transmitter Front Panel

The transmitter has the following indicator LEDs and connector:
A
B
Figure 5.
A
B
C
E
STATUS
LINK
CONFIG
HOST
A A A B B
Power LED Host LED
C
Config port Link LED
E
Transmitter Front Panel
Power LED — This green LED lights to indicate that the unit is receiving power.
Config port — Connect a 9-pin D-to-2.5 mm TRS cable from a computer to
this 2.5 mm TRS jack for RS-232 communication (see
Communication on page 13). The Config port enables serial communication with
the computer for configuration and control of the transmitter via SIS commands (see
Remote Configuration and
NOTE: You can connect the computer to either the transmitter or the receiver.
Host LED — This green LED lights when both the transmitter and receiver are powered
and correctly connected by the appropriate fiber optic cable, and the transmitter is
communicating with the host PC.
The LED blinks when the transmitter and receiver are both powered and connected, but
no USB devices are attached.
Link LED — This green LED lights when the transmitter and receiver are correctly
connected together by the fiber optic cabling and are receiving power.
FOX T/R USB Extender Plus • Installation and Operation
E E
FOX T USB EXTENDER Plus
C C
Connecting for Serial
Control, beginning on page 16).
9