Wall Controller Operation - Friedrich VRP12K Service And Parts Manual

Wall Controller Operation

Wall Controller Operation
VRPXWC
Mode:
Cycles between
Heat, Cool or Fan Only
Fan:
Sets fan to either
-cycle automatically
run continuously
Speed:
Sets fan speed
Low, Med, High or Auto
Push Buttons
There are three control push buttons on each side of the display. Each Push Button illuminates to indicate that the power
is on. The backlight on the Push Buttons will automatically dim to 20% intensity after 15 seconds of inactivity.
Display
The display is a high efficiency LCD with a built-in white backlight. The backlight has an automatic two (2) step
dim function. After 15 seconds of inactivity, the display dims to 20% intensity. After an additional 120 seconds, the display
switches off. Touching any button automatically changes the display to full brightness. [Unless the Motion Sensor is
activated.]
VRPXEM(W)RT1/2
Energy management wall controller with an
occupancy sensor
WIRED VRPXEMRT2
WIRELESS VRPXEMWRT2
Note: For VRPXEMRT2 and VRPXEMWRT2
please refer to respective Installation and Op-
erations Manuals
28
35
OPERATION
Fan
Only
Cool Heat
88
AUTO FAN
CONTINUOUS
AUTO SPEED
Proximity
Sensor
Fan Speed
Auto Speed
selected fan
Automatically Selects
speed
Best Fan Cooling Speed
Control
Locked
Wait
F
C
AM
PM
SET POINT
ROOM TEMP
CHECK
FILTER
Filter
Check/Clean
2 Digits Display
Shows setting for:
-Set point (Temperature)
-Room Temperature
VRPXEM(W)RT2
Temperature
Increment 'Up'
Temperature
Increment 'Down'
ON/OFF
Turn unit
on/off