Before Installation, Reinstallation Or Troubleshooting; Before Start-Up; During Operation; Misc - Linak Deskline DL20 IC User Manual

Before installation, re-installation, or troubleshooting
• Stop the DL
• Pull out the mains plug.
• Relieve the DL of any loads, which may be released during the work.

Before start-up

• Make sure that the system has been installed as instructed in this User Manual.
• Make sure that the voltage of the control box is correct before connecting the
system to the mains.
• System connection. The individual parts must be connected before connecting the
control box to the mains. See the User Manual for LINAK actuators, if necessary.

During operation

• If the control box makes unusual noise or smells, switch off the mains voltage
immediately.
• Take care that the cables are not damaged.
• Unplug the mains cable on mobile equipment before moving it.
• The products must only be used in an environment, that corresponds to their IP
protection.

Misc.

The actuator system has a sound level below 55 dB (A) in typical applications.
Updated manuals and declarations can always be found here:
www.linak.com/deskline
Page 7 of 32