Safety Instructions; Before Installation, Reinstallation Or Troubleshooting; Before Start-Up; During Operation - Linak DESKLINE DL2 User Manual

Safety instructions

Failure to comply with instructions marked with the warning symbol may result in
accidents involving serious personal injury.
Failure to comply with instructions marked with the "NOTE" symbol may result in
serious damage to the system or one of its components.
Persons who do not have the necessary experience or knowledge of the product/
products must not use the product/ products. Besides, persons with reduced
physical or mental abilities must not use the product/products, unless they are
under surveillance or they have been thoroughly instructed in the use of the
apparatus by a person who is responsible for the safety of these persons.
Moreover, children must be under surveillance to ensure that they do not play with
the product.
It is important for everyone who is to connect, install or use the systems to
have the necessary information and access to this User Manual.
If there is visible damage on the product it must not be installed.
The appliance is not intended for use by young children or infi rm persons
without supervision.
Young children should be supervised to ensure that they do not play with the
appliance.
Before installation, de-installation or troubleshooting:
• Stop the DL2
• Switch off the power supply and pull out the mains plug.
• Relieve the DL2 of any loads, which may be released during the work.

Before start-up:

• Make sure that the system has been installed as instructed in this User Manual.
• Make sure that the voltage at the control box is correct before the system is
connected to the mains.
• System connection. The individual parts must be connected before the control
box is connected to the mains. See the User Manual for LINAK actuators, if
necessary.

During operation

• If the control box makes unusual noises or smells switch off the mains voltage
immediately.
• Take care that the cables are not damaged.
• Unplug the mains cable on mobile equipment before it is moved.
• The products must only be used in an environment, which corresponds to their IP
protection.
5