Connecting The Sensor Cables To The Sensor - Siemens SITRANS FS230 Compact Operating Instructions

Connecting

4.3 Connecting the sensor cables to the sensor

5. Tighten the F-connector using the tool until you meet a mechanical stop.
6. Remove the F-connector tool.
7. Mount and tighten the cable gland.
Repeat these steps for each sensor cable.
4.3 Connecting the sensor cables to the sensor
Note
The following example is shown in the Reflect mount sensor configuration.
Connect sensor cables to the sensor as follows:
1. Fill connector end with the supplied grease prior to connecting.
2. Apply the supplied grease to the internal threads at the large end of the thread connector.
3. Observing the upstream and downstream orientation
from the transmitter port (1A) to the sensor
36
⑥
, connect upstream sensor cable
⑤
and make connection snug.
Compact Operating Instructions, 05/2021, A5E38755607-AC
③
SITRANS FS230