Raisecom
ISCOM6860 (A) Hardware Description
3.8.2 Panel and slots
The XP2A card can be inserted into slots 10 of the ISCOM6860 chassis.
Figure 3-8 shows appearance of the XP2A card.
Figure 3-8 Appearance of XP2A card
3.8.3 Interfaces
There are 2 interfaces on the XP2A card. Table 3-31 describes the interface type and usage.
Table 3-31 Interface descriptions of XP2A card
1–2
3.8.4 LEDs
There are 3 LEDs on the XP2A card. Table 3-22 lists descriptions of these LEDs.
Table 3-32 LEDs on XP2A card
SYS/ALM
Name
Type
SFP+
LED
Number
1
Raisecom Technology Co., Ltd.
Usage
10GE Ethernet optical
interface
Status
Green
System working status LED
Fast blinking green (4 Hz): the system is being
initialized.
Slow blinking green (1 Hz): the system is
working properly.
Off/Green: the system is working improperly.
Red
Alarm LED
Blinking red: the card is inserted improperly.
Red: a fault is generated.
Off: no fault is generated.
Orange Standby LED
Orange: the card is in standby status.
Off: the card is not in standby status.
When the card is in standby status, other
LEDs are off.
Description
Available optical modules:
10GBASE-LR/LW
10GBASE-SR/SW
Description
3 Cards
24