Raisecom
ISCOM6860 (A) Hardware Description
When connecting or removing the LC/PC fiber connector, align the connector with the optical
interface, and do not rotate the fiber. Note the following points:
SC/PC fiber connector
Figure 4-2 shows the SC/PC fiber connector used by the ISCOM6860.
Figure 4-2 SC/PC fiber connector
When connecting or removing the SC/PC fiber connector, align the connector with the optical
interface, and do not rotate the fiber. Note the following points:
4.1.3 Wiring
Table 4-3 lists wiring of fiber.
Table 4-3 Wiring of fiber
Single-fiber
connection
Dual-fiber
connection
Align the head of the fiber jumper with the optical interface and insert the optical fiber
into the interface gently.
To remove the fiber, press the latch on the connector, pull the fiber connector inward
slightly, and pull the fiber out.
Align the head of the fiber jumper with the optical interface and insert the optical fiber
into the interface gently.
To remove the fiber, press the latch on the connector, pull the fiber connector inward
slightly, and pull the fiber out.
Wiring
Optical interface of
local device
Optical interface
Optical interface Tx
Optical interface Rx
Raisecom Technology Co., Ltd.
Direction of optical
signal
<->
->
<-
4 Cables
Optical interface of
peer device
Optical interface
Optical interface Rx
Optical interface Tx
34