Ignition Coil Air Gap Check; Ignition Coil Inspection - Honda FJ500 Manual

62V42000.book 6 ページ ２０１２年１２月７日 金曜日 午前９時１７分
dummyhead dummyhead
IGNITION SYSTEM
IGNITION COIL AIR GAP CHECK/ADJUSTMENT
• Avoid the magnet part of the flywheel when
adjusting.
• Adjust the ignition coil air gap equally on both side.
Remove the fan cover (page 7-3)
Measure the ignition coil air gap clearance.
IGNITION COIL AIR GAP:
0.20 – 0.60 mm (0.008 – 0.024 in)
If measured clearance is out of specification, adjust the
clearance.
Loosen the two ignition coil bolts (6 x 25 mm) [1].
Insert the thickness gauge [2] of proper thickness
between the ignition coil [3] and flywheel [4].
Push the ignition coil firmly against the flywheel and
tighten the ignition coil bolts securely.
Remove the thickness gauge.

IGNITION COIL INSPECTION

Remove the fan cover (page 7-3).
PRIMARY SIDE
Disconnect the ignition coil connector [1].
Measure the resistance of primary coil by attaching one
ohmmeter probe to the ignition coil wire terminal [2] and
the other at the iron core [3].
RESISTANCE: 0.69 – 0.83 Ω
If measured resistance is out of specification, replace
the ignition coil.
7-6
[3]
0.20 – 0.60 mm (0.008 – 0.024 in)
[4]
0.20 – 0.60 mm (0.008 – 0.024 in)
[2]
[1] [2]
[1]
[3]