Honda FJ500 Manual page 104

62V42000.book 3 ページ ２０１２年１２月７日 金曜日 午前９時１７分
dummyhead dummyhead
HANDLE COLUMN DISASSEMBLY/ASSEMBLY
SER, SE TYPE
Remove the handle column assembly (page 14-2).
Disassemble the following:
– Engine stop switch (page 7-8)
– Clutch lever (page 14-5)
– Throttle lever (page 14-7)
HANDLE ADJUSTING LEVER
HANDLE COLUMN COVER
CABLE GUIDE
CHANGE STOPPER PLATE
HANDLE COLUMN
(Change lever holder
sliding surface)
Align
WASHER (12 mm)
HANDLE PIPE
NUT
WASHER
(10 mm)
RETURN SPRING
LOCK PIN (12 mm)
NOTE 1 When reassembly, install the long side against the handle column.
NOTE 2 When reassembly, apply ThreeBond® 1530C or equivalent to the inside.
Align
HANDLE LOCK NUT
HANDLE COLUMN COVER SCREW (5 x 12 mm) (2)
3 N·m (0.3 kgf·m, 2.2 lbf·ft)
CABLE GUIDE SCREW (5 x 10 mm)
3 N·m (0.3 kgf·m, 2.2 lbf·ft)
CHANGE COVER
CHANGE LEVER
BOLT (6 x 10 mm) (2)
BOLT (6 x 10 mm) (2)
(Change lever sliding surface)
CHANGE LEVER HOLDER: NOTE 1
BOLT/WASHER (6 x 12 mm)
HANDLE
R. HANDLE GRIP: NOTE 2
L. HANDLE GRIP: NOTE 2
CHANGE LEVER GRIP: NOTE 2
–
–
14-3