Honda FJ500 Manual page 47

62V42000.book 6 ページ ２０１２年１２月７日 金曜日 午前９時１７分
dummyhead dummyhead
FUEL SYSTEM
GOVERNOR ROD REMOVAL/INSTALLATION
Pull the carburetor toward a point where the groove [1]
in the throttle arm [2] lines up with the governor rod [3],
and lift the rod out of its hole and unhook the throttle
return spring [4].
Installation is in the reverse order of removal.
CARBURETOR DISASSEMBLY/ASSEMBLY
Gasoline is highly flammable and explosive. You
can be burned or seriously injured when handling
fuel.
• Keep heat, sparks and flame away.
• Handle fuel only outdoors.
• Wipe up spills immediately.
• To prevent serious eye injury, always wear
safety goggles or other eye protection when
using compressed air.
• Turn the fuel valve lever to the "DRAIN" position
and drain the fuel before disassembling.
Fuel vapor or spilled fuel may ignite.
• The pilot screw adjustment and removal can not be done.
• If clean the valve seal, replace it with a new one for molybdenum coating coming off.
• If remove the throttle stop screw, adjust the engine idle speed (page 3-9).
Remove the carburetor (page 5-5).
5-6
[1] [3]
[2]
[4]