Honda FJ500 Manual page 142

PULLEY/V-BELT REMOVAL/INSTALLATION
After installation, adjust the V-belt tension (page 3-10).
UPPER BELT STOPPER
ENGINE ADJUST PLATE
BOLT (8 x 16 mm) (4)
LOWER BELT STOPPER
DRIVEN PULLEY BOSS
DRIVE PULLEY: NOTE 1
DRIVE PULLEY BOLT (8 x 22 mm)
26.5 N·m (2.7 kgf·m, 20 lbf·ft)
NOTE 1
NOTE 2
NOTE 3
NOTE 4
RUBBER
HOLDER
WASHER (8 mm)
V-BELT: NOTE 4
BELT COVER
DRIVE PULLEY REMOVAL/INSTALLATION
DRIVEN PULLEY REMOVAL/INSTALLATION
Note the installation direction.
Before installation, check that there is no crack and abnormal wear-out in
the belt and replace if necessary.
BRACKET WASHER
GROMMET: NOTE 3
ENGINE
STAY
BOLT
(8 x 16 mm)
ENGINE STAY
BOLT (8 x 20 mm)
DRIVEN PULLEY: NOTE 2
BOLT (6 x 10 mm) (3)
BOLT (8 x 18 mm)
2
BELT COVER STAY
HEX BOLT (6 x 8 mm)
BOLT (6 x 12 mm)
BELT STOPPER C
TRANSMISSION SIDE
BELT COVER STAY BOLT/
WASHER (6 x 16 mm)
6 N·m (0.6 kgf·m, 4.4 lbf·ft)
BOLT (6 x 8 mm)
page 11-3
page 11-3
–
–